1797 $10 (1797 Eagle) NGC AU58. This near mint state, early date gold eagle has significant mint luster remaining within the devices on both sides. The obverse has an average strike, but the reverse has a strike that is far above average. We see full details on the upper part of the shield, the lower part of the eagles neck, the eagles wings, about half of the stars above the eagle, and the clouds. The reverse also has full dentils. Light adjustment marks are seen on the upper left side of the obverse. Sufficient separation exists in the lines of Liberty hair and gown to warrant the grade. For the grade, the surfaces are clean and free of distractions.

Robert Scot designed the gold eagle. The obverse design shows a profile of Liberty facing right. Below her is the date which is off center to the left. Between the date and the word LIBERTY on the left side of the coin are ten stars. Another six stars follow LIBERTY down to the bust. (There were other numbers and arrangements of the stars including ten and five, and twelve and four among the early eagles.) Liberty wears a large, soft cap. Her hair flows down and also shows on her forehead. The design was probably taken from a Roman engraving of a Greek goddess. Libertys cap was certainly not a Phrygian or liberty cap. The liberty cap, emblematic of freedom, was worn by freed slaves and freed gladiators in Roman times. It was a close fitting cap used to cover a shorn head, which was one of the way slaves were identified. Because of the way Libertys hair strands wrap around it, the oversized cap has been called a turban, and the design has been called the Turban Head because of it.

The Type 2 reverse, issued in 1797, shows a heraldic eagle. However, Scot mixed up the positions of the arrows and olive branch. The arrows held in the wrong claw signify defiant militarism. Either Scot made an error copying the image of the Great Seal, or he deliberately changed the symbolism in keeping with very warlike stance. Considering that the United States at this time was engaged in a naval war with France (the undeclared Franco-American War of 1798 to 1800, which took place on the East coast of North America and the Caribbean and resulted in the end of French privateer attacks on U.S. shipping), the latter is probably more likely. The French would be especially sensitive to a message within the heraldry, and the young United States was brash in that they had just defeated the super power, England in gaining independence. In the field above the eagle are thirteen stars and above them, six (or seven) clouds. A banner from wing to wing has the motto E PLURIBUS UNUM.
The year after this coin was issued the Mint realized that it was impractical to keep adding stars to the obverse for each new state admitted to the union, and they were standardized to thirteen, although in different arrangements.

Thomas Jefferson chose Robert Scot to be the first Chief Engraver of the United States Mint on November 23, 1793. Scott was born in 1744 in Edinburgh, Scotland or England. (Documentary evidence is lacking as to where he was born.) He was trained as a watchmaker in England and learned engraving afterwards. He moved to the United States in 1777, where he worked as an engraver of plates, bills of exchange, and office scales. During the Revolution, he was an engraver of paper money. In 1780 he was made the State Engraver of Virginia. He moved to Philadelphia the next year. He was appointed Chief Engraver of the United States Mint on November 23, 1793 by David Rittenhouse, Mint Director. His salary in 1795 was $1,200 per year. The Mint Director received only $800 dollars per year more. Scots ability to make dies was limited, and he was advanced in years with failing eyesight. His work was somewhat less than that done in Europe at the time, and Scot was criticized for its poor quality. He was responsible for designs of most of Americas first coins. These include the Flowing Hair and the Draped Bust motifs used on the early silver coins, and the gold quarter eagle, half eagle and eagle. Scot also designed the 1794-1797 half cent, the 1800-1808 draped bust half cent, and the Thomas Jefferson Indian Peace Medal. Scot died on November 1, 1823 and was succeeded by William Kneass as Chief Engraver.

Record keeping in the Mints early years was fairly inaccurate. At the end of the eighteenth century Philadelphia had recovered from the British occupation and Revolutionary War. It was the second largest city in the English-speaking world, but it could do nothing to protect its citizens from the mosquito-borne epidemic of yellow fever. Its wealthy citizens went to the countryside to escape, and the poor grimly waited their fate. Of course these annual epidemics caused havoc with all manufacturing that required continuity, such as a coinage sequence. In addition to yellow fever, chaos at the Mint was also caused by chronic bullion shortages, coin dies that would wear out and had to be re-engraved because they were not taken out of production until they failed completely, and a Chief Engraver, Robert Scot, who was in his seventies and had failing eyesight.